Welcome to my blog, the story of my continuing journey into the World of Zombie Wargames.

Monday 18 November 2013

Playtime (The Park part 3)

The more observant amongst you will have noted that I've actually dropped the wip part in the title, this of course is for a very good reason in so much as I've finally finished the Park !
I do however wish to show the separate bits I've made to bulking the inside of the park.
It was difficult deciding what to include (flower beds, fountains, general greenery all came to mind, but my initial thoughts were for a children's play area. I opted for just three items to be included, a swing-set, a slide and a see-saw. I thought these would be fairly easy to make out of scrap and were typical of a play area.

 The slide is entirely made from thin card but has a core of polystyrene in the solid support.
I went for a solid stairs end mainly for ease, similarly with the support rails for what really should have been typically been iron stairs (or similar).
I did miss out on a trick that I only thought about afterwards in that at the top of the slide I should have built some form of platform, this would have enabled me to have placed a figure at the top. The slide's current width of  about 20mm really prevents this.

The second piece of equipment is a see-saw, made from various bits of scrap plastic; the central cross-beam is a bit of sprue, suitably filed down.

This was another one of those models that I'd started and wished I really hadn't. It's so small and fiddly to make it look right.
The base itself is not a single piece of scrap, but two pieces glued to the central upright for added strength.


The final bit of equipment is the swings set.
The frame of this is again two bits of identical right-angled sprue glued at what looked by eye to be an appropriate angle.
I had enough space between the angles to get two actual swings in the gap without it looking complete pants.








 The slide was given a wash of filler over the rear steps before painting started.
 The pale green slide, turned into the garish yellow and green slide before I opted for the red and blue slide you seen here.
As in all my models the bright cheerful colours I had settled on were then abused with washes and splashes of various browns to represent the wear and tear of neglect on a rusting playground.


 The see-saw had two holes drilled into the upright pieces and paper clip handles, cut to size, glued into them.
Again the yellow and red turned to blue and red and was suitably "weathered".
I'd decided that the base would be painted to represent a dull concrete for contrast, rather than a rusting metal plate.
Little did I know that when starting the swings, what a veritable pain in the posterior attaching the actual chains to the uprights and the seats to the chains, would be.
The chain is from a cheap bit of jewellery, kindly donated by SWMBO (knowingly, if you were wondering) and the seats are more sprue.
I think I probably spent more time putting the chains and seats on this than I did making all of the above. The chains were eventually superglued into stiff lengths (thus it's not a working model).
Once more weathering was applied to the blue uprights (its original intended colour).

Once more that's all for this week. Next week's blog will show the elements that finish off  the Park's internal bits, featuring, once more, the use of coffee stirrers (just for Clint ).

As always your comments are both welcomed and appreciated.








22 comments:

  1. Looking good, as usual...I'll stop saying that now as I keep repeating myself.

    I feel the need to mention I had this great idea of making a park and then painting hasslefrees kids survivors (and grandma as their guardian) and studio miniature's kids zombies so they could do some bashing, but atm, if we were competing, you'd be a park ahead!

    I can only imagine how many dreams were shattered working on the see saw and the swings. The gravity and fiddly bits always kill the cool images of a finished pieces I make in my head before I start working on them!

    ReplyDelete
    Replies
    1. Thanks Mathyoo, you're right about dreams. My best efforts are those that I've though over for a good while. The finished park I'm sure will make a good centrepiece for a fight.

      Delete
  2. Nice work again Joe,
    I did try a while back to make a swing set pretty similar. Exact sprue frame, some twisted wire for the chain and a bit of a (your favourite) coffee stirrer for the seats. Gave up after many failed attempts to glue the damn thing together! I'll have to try again as it obviously can be done!

    ReplyDelete
    Replies
    1. Thanks Dave, it was nearly going to be the broken swing with the bits on the ground. I really should have gone with solid swing arms as they'd have been much easier and not completely unknown.

      Delete
  3. I don't think it matters too much that the swings and the see-saw don't work. they're only meant to be scenery and in that they serve their purpose. They look good and it just goes to show what can be done with scraps and a lot of imagination.

    ReplyDelete
    Replies
    1. I'm in total agreement, but I think the first thing that people will want to do is see if the swings swing !

      Delete
  4. Looking great. Wish I had the patience.

    ReplyDelete
    Replies
    1. Thanks Colin, I've got time rather than patience.

      Delete
  5. Very cool scratch building indeed, although my mind boggles at the patience involved! The weathering on the frames really brings them to life and gives a grimy realism that a zombified play ground encounter deserves. Perhaps some tags and dog poop could enhance the bleakness :) Inspirational stuff!

    ReplyDelete
    Replies
    1. Thanks HH, I've tried tagging on my construction site, with a larger "canvas", but these are a bit too small for me.

      Delete
  6. Very nice stuff, the slide is fantastic, well done mate

    ReplyDelete
    Replies
    1. Thanks SK, but fantastic is a bit ott for a bit of cardboard.

      Delete
  7. I do like the weathered appearance - very effective at making these items look a bit abused and unloved!

    ReplyDelete
    Replies
    1. Thanks C6, they do have tp look the part after the apocalypse too.

      Delete
  8. Nice work. The swing set is definitely my favourite! Its inspiring to see some one put so much love into an project like this!

    ReplyDelete
    Replies
    1. Thanks you so much David, to be told I'm inspiring is very humbling as i jave never set out to be so. I don't think there were many words of love said though when I made the swings (also my favourite)

      Delete
  9. Love the weathering, good job, these look great. Some playes may poke the swings... tell them not to before a game :)

    ReplyDelete
    Replies
    1. Thanks ZA, yep I can think that pushing the swings to see if they work would spring to most players minds, just like rotating a tanks turret, to see if it does.

      Delete
  10. I like these a lot. Well executed.

    ReplyDelete
  11. This is damn fine work Joe. You should be proud of it all - justifiably so.

    ReplyDelete
    Replies
    1. Thanks Colin, I'm rarely proud of my stuff, but I'm always pleased to see it finished.

      Delete